Paver sealing for Cedar Hills homes
Paver Sealing in Cedar Hills, FL
Mid-century Cedar Hills, from Blanding Boulevard to the Cedar River, can get a free paver sealing estimate at (904) 541-9860.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Fast, careful paver sealing in Cedar Hills
Cedar Hills homeowners can book paver sealing with a free estimate, whether the pavers sit out front, beside the garage or behind the sliding door. A local contractor washes the surface, refills the joints with sand and rolls on the coat. Hear back within 1 business day, usually much sooner; the quickest way in is (904) 541-9860.
Say your patio has gone gray and the joints have thinned out since the last time you looked. Cleaned, re-sanded and sealed, the same pavers can look new again, and the whole back of the house feels fresher. Prefer to write first? You can get a free estimate and describe the spot.
Why hire a local paver sealing contractor in Cedar Hills?
In Cedar Hills the houses are mid-century ranches and the pavers are usually much newer, so each job starts with a question about history. A local contractor asks it before quoting, and you can get a free estimate if you would like to see how that goes.
Free visit, written price
The contractor measures your Cedar Hills drive, walk or patio and writes the price down. Nothing is due for the visit, and you keep the paper.
Prices you can check
Prices posted around Northeast Florida run $1.75 to $3.25 per square foot for the whole job. Compare any bid to that.
Matte or wet look
Matte suits a brick ranch and hides tire marks. The wet look pops color but shows scuffs sooner.
No pressure
You pick the day and the finish, or you pass. Every Cedar Hills estimate comes free of obligation.
Get Your Free Estimate in Cedar Hills
Tell us about your pavers in Cedar Hills.
Free, no obligation
What paver problems show up most in Cedar Hills?
Chalky color from long summers
NOAA normals reported by News4JAX put Jacksonville summer highs near 91 degrees. Cedar Hills ranches sit well back from the street, so the drive is long and open to that sun. One Jacksonville company says unsealed concrete pavers lose noticeable color in three to five years. A new coat brings the tone back, once the surface is clean. Matte holds up well on a drive like that. If your garage faces west, the afternoon hours are the hardest on the color near the door. Pavers that face the street often fade first, because nothing shades them.
A dip where the drive meets the garage
A driveway carries a few tons each time a car pulls in, according to a Jacksonville sealing company, and turning tires loosen the sand under the apron. Over time the pavers there creep and settle. Sealing locks in whatever is there, so a sunken spot gets reset first. Show the contractor any dip, since small ones are cheaper to fix now than after another wet year. A sealed apron also sheds oil drips better, so the spot stays easier to keep clean.
Water that lingers after storms
In August 2017 News4JAX reported that a blocked storm drain in a Cedar Hills ditch sent water into neighboring yards. The median elevation in Cedar Hills Estates is about 27 feet, and none of 33 sampled homes sits in a FEMA flood zone. So the worry is slow drainage, not river water. Wet pavers hold dirt and cannot take sealer, which can add a few days to the schedule. Ask the contractor to check the lowest corner of the drive last, since that is where water leaves last. It is also worth telling the contractor if a neighbor's yard drains toward yours.
Joints that thin out each summer
Jacksonville gets about 53 inches of rain a year, and the 1991 to 2020 normals show the biggest rise in summer and autumn. Fast runoff carries joint sand away. Soil moves in, and weeds follow. A landscape trade guide rates sealed joint sand as the strongest defense against them. Fresh sand goes in first, then the coat holds it. Edges along the lawn lose sand first, which is why they get a second pass. Ants use the same gaps, since insects burrow in loose sand and carry it out.
A coat laid by a past owner
Homes in Cedar Hills Estates were built between 1955 and 1971, so many have changed hands more than once. Nobody may remember what product went on the pavers. A water-based coat cannot go over a solvent-based one, and white or flaking old sealer has to be stripped first. A Jacksonville company says water that beads means a coat still works and water that soaks in means it is spent. The contractor can read the signs in a few minutes and tell you which of the two you have. Receipts, labels or a neighbor's memory can speed the answer.
Does it matter which Cedar Hills street I live on?
Not for the method, since most of Cedar Hills was built as one-story brick or block ranches on wide lots. Storybook streets such as Mother Goose Road and Peter Pan Place get the same wash, sand and seal as anywhere else. What changes from lot to lot is how much pavement there is. Tell the contractor your street when you get a free estimate.
The Cedar River shore is the exception. Metro Jacksonville says many homes there have been expanded or replaced with much larger ones, so the patios and pool decks tend to run bigger too. More pavement means a bigger quote even at the same rate. If your lot backs onto the river, call (904) 541-9860 and give a rough size in feet.
Homes in Cedar Hills Estates run from about 910 to 3,248 square feet, and many listings there say there is no HOA. Check your closing papers to be sure. If you do belong to an association, get its written color rules before choosing a finish, then get a free estimate.
What does paver sealing cost in Cedar Hills?
The going range for a full clean, sand and seal in Northeast Florida is $1.75 to $3.25 per square foot, as companies post it. A Cedar Hills drive that runs long from the garage to the street adds up fast at any rate. Small patios cost more per foot, since prep takes the same time on a small area as on a big one. For a firm number, get a free estimate.
The old coat moves the price more than anything else. White, hazy or flaking sealer has to be stripped first, which adds hours. A job that covers the drive, walk and patio together spreads the setup over more square feet. Call (904) 541-9860 and the contractor can say what applies to your house.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $525 to $975 |
| 600 sq ft | Two car driveway | $1,050 to $1,950 |
| 1,000 sq ft | Large driveway or pool deck | $1,750 to $3,250 |
| 1,500 sq ft | Driveway plus pool deck | $2,625 to $4,875 |
Math based on the $1.75 to $3.25 per square foot that Northeast Florida paver companies published as of November 2026. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.
How does a paver sealing job work in Cedar Hills?
Walk the drive and read the surface
First the contractor walks from the street to the front door and around to the patio. Low spots near the garage are flagged for repair, since sealing locks in whatever is there. Water on the surface tells a story too. If it soaks in and darkens the paver, an old coat has worn out. That first look also tells the contractor how much sand and sealer to bring, so the visit does not stall halfway. Take a minute to point out any spot where you have seen a puddle after a storm.
Wash gently
Hard blasting can loosen joints and throw sand around, so the pressure is kept to what the paver can take. Gray film, algae and spots lift off. Brick walls and flower beds beside the walk get a light rinse or a cover. This is the step that brings the color back. A clean surface also shows any cracked or sunken pavers that were hiding under the grime.
Re-sand the joints
The wash takes some sand with it. New sand goes in until the joints are full and the edges feel firm. A low-contrast sand shade hides dirt and keeps the surface looking even. A last sweep clears the extra. One local company offers six sand shades, so you can pick the one closest to your pavers.
Let the surface dry
Sealer goes on dry pavers or not at all. One local company warns against sealing damp pavers or sealing ahead of a heavy storm. Spring and fall often give the steadiest weather. A shady strip by the fence may need an extra day. Wind and sun speed things up, and a humid morning slows them down. A sprinkler timer that wets the pavers can undo a dry window, so mention yours.
Roll on the coat
The sealer is sprayed and then back-rolled so it sinks into the joints and lies flat. Plan to walk on it in a few hours and park off it for about a day. If you chose a wet look, ask about scuffs near the garage. Water that beads afterward means the job took. Ask for the sealer's product name before the crew leaves, because it matters the next time.
Complete paver services in Cedar Hills
Four things happen on a Cedar Hills job, in this order: wash, sand, dry, seal. The order matters because sealer locks in whatever sits under it. Skip a step and you may see the problem again in a year. To plan the days around your work week and the forecast, call (904) 541-9860.
Your drive carries cars and takes the afternoon sun. Your front walk takes feet and the mower, and the back patio takes the grill and the chairs. A pool deck, if you have one, may need a penetrating sealer so it stays grippy when wet. Say which of these you have, and get a free estimate to get each one priced.
A film sealer stays on top and ties the joint sand together. A penetrating sealer soaks in and leaves the look as it was. Either one has to suit what is already on the surface, because a water-based coat cannot go over a solvent-based one. To talk through the choice, call (904) 541-9860.
Summer in Jacksonville means short, heavy storms, so a Cedar Hills job waits for a dry run of days. Spring and fall are often the steadiest seasons for sealing. The contractor will tell you if the forecast pushes things back a day or two, and why. To pick a date, get a free estimate.
Questions to ask before you hire
- What will you need from me that day, such as a hose, an outlet or an open gate?
- Can you lift and reset the pavers that have sunk near my downspouts?
- How long should my kids and my dog stay off the pavers after the sealer goes on?
- How do you clean older pavers without wearing down the surface?
- How do you deal with weeds and ant hills coming up through the joints?
- Will the sealed pavers turn slick when they get wet around the pool?
- Where does the wash water go, and how do you keep it out of the storm drain?
What do sealed pavers look like around Cedar Hills?
Why local matters in Cedar Hills
A contractor who works Cedar Hills knows the front setbacks are deep and the walks to the door are long. That adds up to more pavement than the house size suggests, and more square feet on the quote. It is worth knowing before anyone measures. To talk with someone who works Cedar Hills streets, call (904) 541-9860.
Ditches and canals run through the neighborhood, and the Cedar River, called Cedar Creek by locals, joins the Ortega River nearby. A contractor who has watched them fill will ask how your yard drains. That answer decides how long the surface needs to dry. If your lot sits low, get a free estimate and mention it.
Most Cedar Hills houses date from the 1950s and 1960s, but the pavers do not. They came later, from whoever owned the home at the time. That is why the first job is finding out what is on the surface, and what it was made to do. Call (904) 541-9860 and pass along anything you know about the last sealing.
Which Cedar Hills landmarks can I use to describe where I live?
Start with the shopping center. Cedar Hills Shopping Center opened in 1955 as one of the city's first large shopping districts outside Downtown, and it still stands at 282,000 square feet. Cedar Hills Elementary followed in 1956, and the Mary Lena Gibbs Community Center fills an armory built in 1957. If you live near any of them, or on the streets between, get a free estimate.
Cedar Hills Park, renovated in 2002, has a pedestrian bridge from nearby backyards. Jefferson Davis Middle School opened in 1961, and Harlow Boulevard carries traffic to Blanding Boulevard and 103rd Street. The neighborhood sits about seven miles southwest of downtown, between Blanding and Lane Avenue. Call (904) 541-9860 and tell the contractor which landmark is closest to your house.
Frequently Asked Questions
Why is paver sealing so expensive in Cedar Hills?
Sealer is only a small slice of the bill. Washing, sanding and prep take hours, and a small patio needs nearly as much prep as a big one, which pushes the per-foot rate up. Prices posted around Northeast Florida run $1.75 to $3.25 per square foot, so test a bid against that. Ask what the quote includes, and whether the washing and sanding are listed.
Which water-based sealer suits Cedar Hills pavers?
That comes down to the coat already there. Water-based sealer never goes over solvent-based sealer, so the contractor tests first. After that it is a choice between a film sealer, which sits on top, and a penetrating one, which soaks in without changing the look. Keep the product name you are given, since it matters at the next coat. Some owners keep a photo of the label for their records.
How long does paver sealing last in Cedar Hills?
Quotes usually assume two to five years. One Jacksonville company says sunny driveways may need a coat at 18 to 24 months and shaded walks at 24 to 36. A long, open Cedar Hills drive suggests the earlier end. Water that stops beading is your cue. Fresh sealer also makes pavers easier to rinse clean between jobs.
How much does it cost to have pavers cleaned and sealed in Cedar Hills?
Expect $1.75 to $3.25 per square foot for the whole job, wash through coat. Where you land depends on the old coat, the sand that went missing and the size of the area. Get the measured square feet on paper, and ask whether stripping is included if the old sealer has failed. Bundling the drive, walk and patio tends to bring the per-foot rate down.
Do I need to ask anyone before sealing my Cedar Hills pavers?
Only if you have an HOA, and many Cedar Hills Estates listings say there is none. Check your closing papers. Florida law keeps an association to what its own papers spell out or clearly imply, so ask to see the rules in writing. A color close to the rest of the street is the easy path.
Will sealing fix a low spot near my garage?
No. A low spot needs a reset before any coat goes on, because the coat would only preserve the dip. The contractor can tell you whether a few pavers need lifting or the base needs more work. Point it out at the first visit so it is priced up front. Small resets are cheaper than waiting a year for the dip to grow. Two or three pavers lifted and reset is a common fix.
When can I park on a freshly sealed driveway?
Plan on walking across it within a few hours and driving on it after about a day. A humid or cloudy stretch slows drying. Ask for the exact wait on your product, and park on the street for the first night. Pool decks and shaded walks may take a little longer to dry. Keep sprinklers off for that first day.
Can sealing stop weeds between my pavers?
It helps a great deal. A landscape trade guide rates sealed joint sand as the strongest weed defense. Sand goes back in first, since sealing over empty joints is how the weeds come back. Pulling weeds alone is a short-term fix.
Ready for a Free Estimate in Cedar Hills?
Call (904) 541-9860 and tell us about your pavers.
Free, no obligation